Filters
Loading…Circuit boards and control panels
Leiterplatten und Bedienfelder für Mikoterm TK-24 Professional Elektrokessel werden für elektronische Regelung, Bedienung, Anzeige und Diagnose des Kessels verwendet. Diese Teile verarbeiten Signale, zeigen Betriebsinformationen an und unterstützen die Ansteuerung von Sicherheitseinrichtungen und elektrischen Komponenten.
Prüfen Sie beim Austausch immer das genaue TK-24 Professional Modell, die Ausführung, die Artikelnummer, den Platinencode, die Softwareversion, die Steckerbelegung, die Versorgungsspannung, die Kommunikationsausführung, die Montageposition und die technische Ausführung. So vermeiden Sie Kommunikationsstörungen, Fehlercodes oder falsche Kesselregelung.
No results.
Mikoterm TK-24 Professional PCBs and control panels
PCBs and control panels for Mikoterm TK-24 Professional electric boilers are used for electronic control, operation, display and diagnosis. The PCB processes signals from sensors, relays, transformer power supply and safety components, while the control panel displays operating status, settings, fault messages and service information.
The correct part selection depends on the TK-24 Professional model, version, part number, PCB code, software version, hardware version, connector layout, supply voltage, communication version, cable length, mounting position and technical design. Always check the original component and technical documentation before replacing a PCB or control panel.
Important checks for PCBs and control panels
- Check whether the PCB or control panel is suitable for the correct Mikoterm TK-24 Professional version.
- Compare part number, PCB code, software version, connector positions, supply voltage, communication version and mounting position with the original component.
- Look for burn marks, moisture, corrosion, loose solder joints, damaged connectors, defective fuses, a poorly readable display or non-responsive buttons.
- Check fault codes, communication between PCB and control panel, sensor readings, switching signals, supply voltage and boiler control response.
- Also assess connected components such as transformer, relays, sensors, wiring, fuses, safety devices and power elements.
Application, replacement and technical points of attention
A PCB or control panel in a Mikoterm TK-24 Professional electric boiler is often inspected or replaced when the boiler displays fault messages, does not start correctly, fails to control components, processes illogical values, does not save settings or has no communication with the control panel. However, a fault is not always caused by the panel or PCB itself.
Diagnosis and installation of electronic and control-related parts should always be carried out by a qualified technician. After replacement, connections, parameters, fault codes, sensor readings, communication, display output, safety devices, boiler parameters and the operation of connected components must be checked carefully.
Frequently asked questions about Mikoterm TK-24 PCBs and control panels
What are PCBs and control panels used for in a TK-24 Professional?
PCBs regulate and control electrical functions inside the boiler. Control panels are used for operation, display, settings, fault messages and service checks.
When should a PCB or control panel be replaced?
Replacement is often required in case of communication faults, error codes, visible damage, defective display output, non-responsive buttons, poor control operation or when measurements show that the part is not functioning correctly.
Does every PCB or control panel fit every TK-24 Professional?
No, correct selection depends on version, part number, PCB code, software version, connector layout, supply voltage, communication version, cable length and mounting position. Always compare it with the original component.
Can a fault also be caused by another part?
Yes, a fault can also be caused by transformer power supply, relays, sensors, fuses, wiring, connectors, safety devices or a defective connected component.
Can users install a PCB or control panel themselves?
Because these parts affect control, safety and electric boiler operation, diagnosis and installation by a qualified technician are required.