Filters
Loading…Fans
At Hewa you will find fans, fan blades and fan motors for ALPS EXCLUSIVE ARTIC and URBAN LINE heat pumps. This category is intended for installers, service technicians and technical buyers looking for parts for airflow, fault diagnosis, maintenance or replacement.
A fan component directly affects airflow across the heat exchanger and therefore the operation, efficiency and reliability of the heat pump. Always check the exact heat pump model, article number, EAN, diameter, motor version, voltage, speed and technical application before ordering.
Fans for ALPS EXCLUSIVE ARTIC and URBAN LINE heat pumps
Fans are used in compatible ALPS EXCLUSIVE ARTIC and URBAN LINE heat pumps to move air across the evaporator. The fan supports heat exchange between the outdoor air and the refrigerant circuit and directly affects efficiency, noise level, airflow and stable operation of the heat pump.
This category includes fan-related components such as fan motors, fan blades and matching service parts. The correct spare part depends on the series, unit type, article number, connection, voltage, rotation direction, diameter, mounting position and technical configuration of the heat pump.
Important checks for fans
- Always check whether the component is suitable for the relevant ALPS EXCLUSIVE ARTIC or URBAN LINE version.
- Compare the article number, fan diameter, motor type, plug connection, voltage, power rating and rotation direction with the original component.
- Check the fan blade for cracks, deformation, imbalance, damaged mounting points or parts touching the housing.
- Check the fan motor for abnormal noise, irregular speed, blockage, fault codes or interruption in the electrical control signal.
- Inspect cables, connectors, PCB control, mounting points and free airflow around the outdoor unit.
Application, replacement and technical attention points
A fan component may need to be replaced in case of insufficient airflow, increased noise, fault messages, vibration, damaged fan blades or a defective motor. Contamination, ice formation, mechanical stress or damage from external influences can also affect fan operation.
Work on electrical and refrigeration-related components must be carried out by a qualified technician. After replacement, the rotation direction, fan speed, airflow, mounting, free running clearance, electrical connection and any controller fault messages should be checked.
Frequently asked questions about fans
What is a fan used for in a heat pump?
The fan moves air across the evaporator of the outdoor unit. This allows the heat pump to extract heat from the outdoor air and operate stably during heating, cooling or domestic hot water production.
When should a fan component be replaced?
Replacement may be required in case of a defective motor, damaged fan blade, imbalance, vibration, abnormal noise, fault codes, insufficient airflow or incorrect electrical control.
Does every fan fit every ALPS EXCLUSIVE heat pump?
No, fans differ by series and unit type. Always check the article number, dimensions, voltage, power rating, connection, rotation direction, mounting position and technical configuration before ordering a component.
Should the air side of the outdoor unit also be checked?
Yes, always check whether the evaporator, air inlet and air outlet are free from dirt, leaves, ice formation or blockages. Restricted airflow can cause fault codes, reduced performance and additional load on the fan.
Can a fan be installed by the end user?
For safe and correct operation, installation should be carried out by a qualified technician. Electrical connection, rotation direction, mounting, controller operation and system checks must be technically verified.