Filters
Loading…signal cable
Signal cables for ARTIC and URBAN LINE heat pumps are used for communication, signal transmission and connection between electronic components within ALPS EXCLUSIVE heat pump systems. These cables are intended for installers and service engineers who need to replace a defective or damaged cable accurately.
Always check the type code, cable length, connector type, wire layout and application within the heat pump. This helps maintain reliable communication between circuit boards, sensors, control panels and control components.
Chico CCX330.45 - XH-4Y signal cable 500 mm
Item no. 600006EAN 8721225900945
Request access
Op nalevering
Added
Chico CCX330.64 - Communication cable 400 + 300 mm
Item no. 600007EAN 8721225900952
Request access
In stock
Added
Chico CCX306.07 - Signal cable 10 metres
Item no. 600008EAN 8721225900969
Request access
In stock
Added
Signal cables for ALPS EXCLUSIVE ARTIC and URBAN LINE heat pumps
Signal cables are used in compatible ALPS EXCLUSIVE ARTIC and URBAN LINE heat pumps for communication, signal transfer and connection between electronic components. Depending on the configuration, signal cables may be used between PCBs, sensors, control panels, control modules, motors or other control components inside the heat pump.
A correct signal connection is important for stable control, reliable communication and dependable operation of the unit. The correct spare part depends on the series, unit type, article number, connector type, cable length, wire configuration, plug shape, mounting position and technical configuration of the heat pump.
Important checks for signal cables
- Check whether the signal cable is suitable for the relevant ALPS EXCLUSIVE ARTIC or URBAN LINE version.
- Compare the article number, cable length, plug connection, wire configuration, connector direction and mounting position with the original cable.
- Inspect the cable for breaks, kinks, damaged insulation, moisture ingress, corrosion, loose connectors or poor contact.
- Look for fault codes, communication problems, missing sensor readings, non-responsive control panels or components that switch irregularly.
- Also check the connected PCB, sensor, control module, wiring harness, connector pins and the technical condition of the complete signal circuit.
Application, replacement and technical attention points
A signal cable may need to be replaced in case of cable breakage, damaged connectors, moisture issues, corrosion or recurring communication faults. Fault codes or illogical measured values can also be caused by a poor connection between a sensor, PCB, control panel or another control component.
Work on electrical control components must be carried out by a qualified technician. After replacement, connector position, cable routing, strain relief, contact quality, communication, fault messages and operation of the associated circuit should be checked.
Frequently asked questions about signal cables
What is a signal cable used for in a heat pump?
A signal cable provides communication or signal transfer between electronic components inside the heat pump. This includes connections between sensors, PCBs, control panels and control modules.
When should a signal cable be replaced?
Replacement may be required in case of cable breakage, damaged connectors, moisture ingress, corrosion, poor contact, fault codes or communication problems between electronic components.
Does every signal cable fit every ALPS EXCLUSIVE heat pump?
No, signal cables differ by series, unit type and technical configuration. Always check the article number, cable length, connector, wire configuration, plug shape and mounting position before ordering a spare part.
Can a fault also be caused by the PCB or sensor?
Yes, a fault may appear to be caused by a defective signal cable while the actual cause is the PCB, sensor, connector, wiring harness or control module. The complete signal circuit must therefore be checked.
Can a signal cable be installed by the end user?
For safe and correct operation, installation should be carried out by a qualified technician. Connector position, cable routing, signal verification and system diagnosis must be technically checked.