Filters
Loading…signal cable
Signal cables for ALPS EXCLUSIVE URBAN V2 heat pumps are used for communication between electronic components within the system. This includes connections between PCBs, sensors, control panels, control modules and other parts that need to transmit signals.
When replacing a signal cable, always check the original cable type, length, connector version, core layout, connection and application within the relevant URBAN V2 model. This helps prevent communication faults, error messages and incorrect heat pump control.
Chico CCX330.45 - XH-4Y signal cable 500 mm
Item no. 600006EAN 8721225900945
Request access
Op nalevering
Added
Chico CCX330.64 - Communication cable 400 + 300 mm
Item no. 600007EAN 8721225900952
Request access
In stock
Added
Chico CCX306.07 - Signal cable 10 metres
Item no. 600008EAN 8721225900969
Request access
In stock
Added
Signal cables for ALPS EXCLUSIVE URBAN V2 LINE heat pumps
Signal cables for the ALPS EXCLUSIVE URBAN V2 LINE are used for communication, signal transmission and connection between electronic components inside the heat pump. They can be used between PCBs, sensors, control panels, control modules, motors or other actuating components.
The correct signal cable selection depends on the series, unit type, article number, connection, voltage, connector type, cable length, core assignment, plug shape, mounting position and technical version. Always check whether the cable matches the original wiring harness or signal connection in the heat pump.
Important checks for signal cables
- Check whether the signal cable is suitable for the relevant ALPS EXCLUSIVE URBAN V2 LINE heat pump and exact unit type.
- Compare the article number, cable length, connector type, plug shape, core assignment, mounting position and technical version with the original cable.
- Inspect the cable for cable breakage, kinks, damaged sheath, moisture, corrosion, loose connectors or damaged pins.
- Check error codes, communication faults, illogical measured values and interrupted signals before replacing the cable.
- Check related components such as PCB, sensors, control panel, control module, wiring harness, power supply and connector terminals.
Application, replacement and technical attention points
A signal cable is usually checked or replaced when communication between components is lost, error codes occur, measured values are illogical or a component does not respond to the control system. The cause may also be a loose connector, moisture ingress, damaged cable sheath or a defective PCB or sensor.
Installation and diagnosis must be carried out by a qualified technician. After replacement, connectors, cable routing, strain relief, signal transmission, error codes and operation of the connected components must be checked again. Prevent cables from being routed against sharp edges, hot parts, moving components or moisture-sensitive areas.
Frequently asked questions about signal cables
What is a signal cable used for in a heat pump?
A signal cable provides communication and signal transmission between electronic components. This includes connections between PCBs, sensors, control panels, control modules and actuating components.
When should a signal cable be replaced?
A signal cable should be replaced when it is damaged, has a cable break, causes communication problems, shows moisture or corrosion damage or no longer transmits a reliable signal after diagnosis.
Does every signal cable fit every URBAN V2 LINE heat pump?
No, the correct version depends on the series, unit type, article number, connection, voltage, connector type, cable length, core assignment, mounting position and technical version.
Can a fault also be caused by a PCB or sensor?
Yes, a communication fault or illogical measured value can also be caused by a defective PCB, sensor, control panel, connector, power supply or control module.
Can a signal cable be installed without a technician?
For correct diagnosis and safe installation, a qualified technician is recommended. The technician checks connectors, cable routing, signal transmission, error codes and operation of the connected components after replacement.